(8)
Eliminate the need for other water defense devices and receive maximum water removal, solids holding capacity and shutdown protection to assure clean, dry fuel delivery while meeting the latest institute of petroleum IP 1583 4th edition
The new Facet HFG Series Horizontal Fuel-Gard monitor housings, equipped with either Facet's FG Series or PS Series 2" (51 mm.) OD monitor cartridges, continually check the entire flow of fuel, not just mere samples, for water or solids contamination. By performing three jobs, the FG Series monitors assure clean, dry fuel. They absorb free and emulsified water, remove ultra-fine solids even when surfactants and fuel additives are present, and shut down the systems flow when hit with a localized ...
(3)
Eliminate the need for other water defense devices and receive maximum water removal, solids holding capacity and shutdown protection to assure clean, dry fuel delivery while meeting the latest institute of petroleum (I.P.) specification
The Facet VFGM Series SuperFlex monitor housings, equipped with FG-O Series 6" (152 mm.) OD monitor cartridges, continually check for the entire flow of fuel, not just mere samples, for water or solids contamination. By performing three jobs, the monitors assure clean, dry fuel. They absorb free and emulsified water, remove ultra-fine solids even when surfactants and fuel additives are present, and shut down the systems flow when hit with a localized slug of water. They are designed to flow from the ...
(4)
A state of the art filtration system designed to prevent water contaminants from entering your aircraft during refueling
The Facet 10 and 20 gpm (38 and 76 lpm) combination fuel monitor/filter water separators conform to Specification MIL-F-8901 and MIL-M- 81380C(AS). They are constructed of light weight aluminum and equipped with a water level sight gauge, manual air vent and drain valve. Inside each housing is a coalescer cartridge, a water separator canister and a monitor. The only variation between these two units is one of height - the 20 gpm (76 lpm) unit is 28 1/4" (718 mm.) high, while the 10 gpm (38 lpm) unit is 18 1/4" (464 mm.) high.
Facet also offers 50 and 100 gpm (189 and 378 lpm) combination fuel monitor/filter water ...
(17)
For maximum water removal, Solids holding capacity and shutdown protection to assure clean, Dry fuel.
The Facet Fuel-Gard monitor cartridge performs three jobs to assure clean, dry fuel. It absorbs free and emulsified water to less than 2 ppm, removes ultra fine solids even when surfactants and fuel additives are present and shuts down system flow when hit with a localized slug of water. It is designed to flow from the outside to inside at a rate of 1 gallon (3.79 liters) per lineal inch with 2 micron nominal filtration.
Fuel-Gard monitors meet the latest edition of the Institute of Petroleum (I.P.) Specifications and Qualification Procedures - Aviation Fuel Filter Monitors With Absorbent Type Elements.
(17)
For maximum water removal, solids holding capacity and shutdown protection to assure clean, dry fuel.
The Facet GNG Series Go-No-Go military fuel contamination monitor housings are constructed of light weight aluminum, and designed for a maximum working pressure of 150 psi.
Facet's GNG Series Go-No-Go military fuel contamination monitors meet the latest edition of Military Specification MIL-M-81380C (AS) for Monitor, Contamination, Aviation Fuel Dispensing Systems.
The GNG Series Go-No-Go fuel contamination monitor housings are offered in four styles :
Model 5 : Equipped with five GNG Series military monitor cartridges - for flow rates from 50 to 100 gpm (189 to 378 lpm) -screwed inlet and outlet connections.
(2)
The Facet 21 Series Fuel-Gard monitors, installed with one Fuel-Gard monitor cartridge, will continually check the entire flow of fuel, not just mere samples, for water or solids contamination. By performing three jobs, this small compact monitor assures clean, dry fuel. It absorbs free and emulsified water, removes ultra-fine solids even when surfactants and fuel additives are present, and shuts down the system flow when hit with a localized slug of water.
Both interior and exterior surfaces of the carbon steel body are epoxy coated to protect against corrosion. This sturdy, single cartridge housing is easy to maintain and requires only 2" (51 mm) base clearance for cartridge change out.
(2)
The Facet Fuel-Gard monitor cartridges meet the latest edition of the Institute of Petroleum (I.P.) Specifications and Qualification Procedures-Aviation Fuel Filter Monitors with Absorbent Type Elements.
The cartridge is made up of layered and pleated, multi-media sections with inner support shells and an outer wrap. A special water absorbent media retains water and the pleats expand. As the maximum water- holding capacity is reached, a reduction in flow occurs, indicating the cartridge should be changed. Maximum recommended operating temperature is 160°F at a maximum differential pressure of 180 psi.
(15)
For maximum water absorption, solids holding capacity and shutdown protection to assure clean, Dry fuel
The Facet 6" (152 mm) nominal outside diameter FG Series Fuel-Gard monitor cartridges perform three jobs to give you clean, dry fuel. They absorb free and emulsified water, remove ultra-fine solids even when surfactants and fuel additives are present, and shut down system flow when hit with a localized slug of water. They are designed to flow from outside to inside at a rate of 4 gallons (15.14 liters) per inch of length.
Facet FG Series Fuel-Gard monitor cartridges meet the latest edition of Institute of Petroleum (I.P.) Specifications and Qualification Procedures - Aviation Fuel Monitors With Absorbent Type Elements.
(17)
For maximum water absorption, solids holding capacity and shutdown protection to assure clean, Dry fuel
The Facet 6" (152 mm) nominal outside diameter FG Series Fuel-Gard monitor cartridges perform three jobs to give you clean, dry fuel. They absorb free and emulsified water, remove ultra-fine solids even when surfactants and fuel additives are present, and shut down system flow when hit with a localized slug of water. They are designed to flow from outside to inside at a rate of 4 gallons (15.14 liters) per inch of length.
Facet FG Series Fuel-Gard monitor cartridges meet the latest edition of Institute of Petroleum (I.P.) Specifications and Qualification Procedures - Aviation Fuel Monitors With Absorbent Type Elements.
(8)
Maximum water removal, solids holding capacity and shutdown protection assures clean, dry fuel
The Facet 2" (51 mm.) nominal outside diameter FG Series Fuel-Gard monitor cartridges perform three jobs - they absorb free and emulsified water to less than 5 ppm; remove ultra-fine solids even when surfactants and fuel additives are present; and shut down system flow when hit with a localized slug of water, giving you clean, dry fuel. The FG Series Fuel- Gard monitor cartridges are designed to flow from the outside to inside at a rate of 1 gallon (3.79 liters) per inch of length.
Fuel-Gard monitor cartridges meet the 4th edition of IP 1583 Specifications and Qualification Procedures - Aviation Fuel Filter Monitors With Absorbent Type ...
(6)
Maximum water removal, solids holding capacity and shutdown protection assures clean, dry fuel
The Facet 2" (51 mm.) nominal outside diameter GNG Series Go-No-Go monitor cartridges perform three jobs - they absorb free and emulsified water to less than 2 ppm; remove ultra-fine solids even when surfactants and fuel additives are present; and shut down system flow when hit with a localized slug of water, giving you clean, dry fuel. The GNG Series Go- No-Go monitor cartridges are designed to flow from the outside to inside at a rate of 1 gallon (3.79 liters) per inch of length.
Go-No-Go monitor cartridges meet the latest edition of Military Specification MIL-M-81380C(AS) for Monitor, Contamination, Aviation Fuel Dispensing Systems.
(2)
Facet's Fuel-Gard® Aviation Spin-On Filters perform three jobs to give you clean, dry fuel. They absorb free and emulsified water, remove ultra-fine solids even when surfactants and fuel additives are present, and shut down system flow when hit with a localized slug of water. The filters are designed to flow at a rate of 13 gpm (FGS-O-405) and 15 gpm (FGS-O-409). A variety of head styles and flow rates are available.
Becker and Associates
